Harman Kardon Citation II - Page 19

17
Check
( )
( )
Yellow to V5-9 (NS). ( 3)
( )
( )
Green to V5-8 (NS). ( 2)
( )
( )
Gray to P4-6 (S). (63)
( )
( )
Violet to P4-5 (S). (64)
( )
( )
Gray to P4-3 (S). (59)
( )
( )
White to P4-2 (S). (58)
( )
( )
Gray to P3-6 (S). (51)
( )
( )
Violet to P3-5 (S). (52)
( )
( )
White to P3-2 (S). (50)
( )
( )
Connect blue wire from harness (62) to S-4R (S).
( )
( )
Connect yellow wire (61) to S-5R (S).
( )
( )
Connect red wire (57) to S-2R (S).
( )
( )
Connect green wire (56) to S-3R (S).
( )
( )
Mount power transformer (PT1) into center hole,
inserting flat washers (Figure K) on studs
between transformer and chassis. Use #10 nuts,
lockwasher under nut. NOTE: Be careful not to
pinch wires. Slip cardboard protective covers over
transformers to prevent scratches during
assembly.
( )
( )
Mount output transformers OT1 and OT2 in
same manner. Use flat washers and #10 nuts,
lockwasher under nut. Use protective covers.
( )
( )
Bend up fuse side tab F2 on fuse holder.
( )
( )
Connect black wire from power transformer to
fuse holder F2 (S).
( )
( )
Connect black/white wire to AC-2 (NS). Slip
large rubber grommet over all remaining leads
coming from power transformer. See Pictorial #6.
( )
( )
Connect green-white lead to V8-G2 (S).
( )
( )
Connect green/red lead to V8-7 (S).
( )
( )
Connect green lead to V8-2 (S).
( )
( )
Connect brown-white lead to V9-G1 (S).
( )
( )
Connect brown/blue lead to V9-2 (S).
( )
( )
Connect brown lead to V9-7 (S).
The red and white leads of the power transformer will be wired after the electrolytic bracket is installed.
( )
( )
Cut one end of 15 ohm 1 watt 5% resistor (brown-green-black-gold) to
½
˝ and connect to V8-8 (S).
( )
( )
Cut the other end
½
˝ and connect to V8-X3 (S). Dress resistor body so that it overhangs socket and
clears pins 1 and 2.
In the same manner, connect the following:
( )
( )
15 ohm 1 watt 5% resistor (brown-green-black-gold) from V7-8 (S) to V7-X4 (S).
( )
( )
15 ohm 1 watt 5% resistor (brown-green-black-gold) from V9-8 (S) to V9-X2 (S).
( )
( )
15 ohm 1 watt 5% resistor (brown-green-black-gold) from V10-8 (S) to V10-X1 (S).