Harman Kardon Citation II - Page 23

21
Check
( )
( )
Cut brown lead to required length. Strip
¼
˝ and tin. Connect to V7-3 (NS).
( )
( )
Similarly, cut brown-white. Connect to V7-6 (S).
( )
( )
Cut blue to required length. Connect to V8-3 (NS).
( )
( )
Cut blue-white to required length. Connect V8-6 (S).
( )
( )
Cut red to required length. Connect to C1 (NS).
( )
( )
Tape leads together.
Similarly on left output transformer OT1. Make the following connections:
( )
( )
Cut brown to required length. Connect to V9-3 (NS).
( )
( )
Cut brown-white to required length. Connect to V9-6 (S).
( )
( )
Cut blue to required length. Connect to V10-3 (NS).
( )
( )
Cut blue-white to required length. Connect to V 10-6 (S).
( )
( )
Cut red to required length. Connect to C1 (NS).
( )
( )
Tape leads together.
( )
( )
Connect long gray lead (60) from wiring harness to E3 (S).
( )
( )
Install terminal board mounting studs (8) in holes
provided. (See Figure L.) Use #6-32 x
⅜
˝ screws,
lockwasher under stud. Insert screw through
chassis and finger-tighten stud onto screw.
( )
( )
Mount terminal boards to standoffs on chassis,
using #6-32 hardware, lockwasher under screw
head. (See Pictorial #8 for proper orientation.)
Tighten standoffs to chassis. (Position harness
and board leads as per Pictorial #6 prior to
mounting boards.)
Starting with right terminal board (TB1) (Channel B)
connect the following (see Pictorial #8):
( )
( )
Connect free yellow lead from terminal 5 of board
(TB1-5) to V2-9 (S).
( )
( )
Connect free yellow lead from terminal 39 of
board (TB1-39) to V1-9 (S).
( )
( )
Dress the shielded wire from TB1-27 between the
board studs, to the right side of chassis, run along
chassis to input jack P2. Connect inner conductor
to P2-3 (S). Connect shield to P2-4 (S).
Similarly on left terminal board (TB2) (Channel A) connect the following:
( )
( )
Connect free yellow lead from terminal 5 of board (TB2-5) to V5-9 (S).
( )
( )
Connect free yellow lead from TB2-39 to V4-9 (S).
( )
( )
Connect shielded lead from TB2-27 as shown in pictorial. Dress under board (below lug #10). Dress
across chassis between AC balance potentiometer and tube socket V9. Place thru hole in electrolytic
bracket and then dress along rear of chassis. Connect inner conductor to P1-2 (S) and shield to P1-1
(S).
Mount choke on side of chassis near P1 using 2 #8-32 screws, lockwasher under nut. Leads should be
nearest to bottom of chassis. See Pictorial #7.
( )
( )
Connect longer yellow lead from choke to C1 (NS).