22
Connect shorter yellow lead from choke to Al (S).
Connect red lead (55) from harness to C1 (S).
Connect one of the blue leads (53 or 54) from harness to D1 (S).
Connect the other of the blue leads (53 or 54) from harness to D2 (S).
Refer to Pictorial #8.
Make the following connections to lower part of lugs of terminal board TB1:
Connect a 10K
½
watt 10% resistor (brown-black-orange-silver) from V8-5 (S) to TB1-1 (S).
Similarly, connect a 10K
½
watt 10% resistor (brown-black-orange-silver) from V7-5 (S) to TB1-
15 (S).
Connect the following wires:
Blue 2
½
˝ long from V7-3 (S) to TB1-16 (S).
Blue 2
½
˝ long from V8-3 (S) to TB1-6 (S).
Make the following connections to lower part of lugs of terminal board TB2:
10K
½
watt 10% (brown-black-orange-silver) from V10-5 (S) to TB2-1 (S).
10K
½
watt 10% (brown-black-orange-silver) from V9-5 (S) to TB2-15 (S).
Blue 2˝ long from V9-3 (S) to TB2-16 (S).
Blue 2
½
˝ long from V10-3 (S) to TB2-6 (S).
Connect the following leads from the harness to the lower section of TB1 lugs:
Repeat as follows for terminal board TB2: