Harman Kardon HK1200 - General Instructions and Safety; Power Supply and AC Receptacles; Power Cord Handling and Installation; Operational Precautions

HK1200/HK1400
DISASSEMBLY
PROCEDURES
(REFER
TO
PAGES
7,14
AND
20}
=
2.
CABINET TOP {AB} REMOVAL
Remove 6 screws (A) and then remove the Cabinet
Top (AB).
[2] FRONT PANEL ASS‘Y (AA) REMOVAL
1.
Remove the Cabinet Top (AB), referring to the pre-
vious step [i].
Remove 5 screws (B) and then remove the Front
Panel Ass‘y (AA).
3] PRE AMP P. C. BOARD (PCB-4) REMOVAL
. Remove the Cabinet Top (AB), referring to the pre-
vious step [i].
. Remove the Front Panel Ass’y (AA), referring to the
previous step [2].
. Remove 2 screws (C) and then remove the Rotary
Knobs (150) and remove the Push Button (147).
. Remove 11 screws (D) and then remove the Pre Amp
P. C. Board (PCB-4).
At this time, unsolder the lead wires connected to
the Pre Amp P. C. Board (PCB-4).
[4} MAIN P. C. BOARD {PCB-1) REMOVAL
1.
2.
Remove the Cabinet Top (AB), referring to the pre-
vious step [1].
Remove 5 screws (£) and then remove the Main P.
C. Board (PCB-1).
At this time, unsoider the lead wires connected to
the Main P. C. Board (PCB-1).
POWER P. C. BOARD (PCB-8) REMOVAL
. Remove the Front Panel Ass‘y (AA), referring to the
previous step [2].
. Remove 3 screws (F) and then remove the Power P.
C. Board (PCB-8).
If necessary unsolder the lead wire.
6} VOLUME P. C. BOARD (PCB-7) REMOVAL
. Remove the Front Panel Ass‘y (AA), referring to the
previous step [2].
. Pull out the Rotary Knob (149).
. Remove hexagon nut (G) and then remove the
Volume P. C. Board (PCB-7).
If necessary unsolder the lead wire.
POWER
CORD
REPLACEMENT
(FOR
SERVICE
ENGINEERS
OTHER
THAN
NORTH
AMERICA)
In order to prevent fire or shock hazard when replacing the power cord, follow the procedure below to replace
the parts with the standard supply parts.
PG1
POWER CORD
Pass the lead: wires through
_the holder to fx,
‘Pinch’ the. ‘power cord with
the holder and fit the
hoider into. the hole-on ane
cabinet back,”
BROWN LEAD
BLUE LEAD
gs
POWER
P. C. BOARD
po