SUB-TS18 SUBWOOFER AMPLIFIER PANEL CONTROLS AND CONNECTIONS 5
SUB-TS18 SUBWOOFER AMPLIFIER PANEL CONTROLS AND CONNECTIONS
¡ Subwoofer-Level Control: Volume
may be adjusted using the
Subwoofer-
Level Control
.
Turn the control clockwise
to increase the SUB-TS18’
s volume
,
or
counterclockwise to decrease it.
™ High-Cut (Low-Pass) Filter Switch:
Placing this switch in the ON position acti-
vates circuitr
y that cuts out all audio input
signals above 120Hz, allowing the SUB-TS18
to focus its power on reproducing the low-
frequency portion of the signal, avoiding
inefficiency and distortion. Engage this filter
when using the
Speaker
-Level Inputs
ª,
or when using the
Line-Level
Full-Range
Inputs
¶, unless your receiver or processor
processes its line-level output using a low-
pass filter. The filter has no effect when the
SUB Input § is used.
£ External
T
rigger Input:
Use the sup
-
plied mini-plug cable to connect the trigger
output of another product to this jack. When
a trigger signal between 3 and 30 volts (AC
or DC) is detected, the SUB-TS18 amplifier
will tur
n on, even when the audio-sense
feature has been activated by placing the
Audio-Sense On/Off Switch ¢ in the
AUTO position. The amplifier will remain
on for about 10–15 minutes without a
trigger signal.
¢ Audio-Sense On/Off Switch: When
placed in the
AUTO position, and when the
Master Power Switch ‚ is turned on, the
SUB-TS18 will automatically turn itself on or
¡ Subwoofer-Level Control
™ High-Cut (Low-Pass) Filter Switch
£ External Trigger Input
¢ Audio-Sense On/Off Switch
∞ Phase Switch
§ Line-Level Subwoofer (SUB) Input
¶ Line-Level Full-Range Inputs
• Speaker-Level Outputs
ª Speaker-Level Inputs
‚ Master Power Switch
⁄ AC Power Cord
HKTS 18 OM 10/6/06 1:34 PM Page 5
To Next Page
Loading...
