13
HKTS 60BQ/230
ENGLISH
Troubleshooting
Troubleshooting
This unit is designed for trouble-free operation. Most problems that users encounter are due to operating errors. So if you have a problem, first check this list for a possible solution. If
the problem persists, consult your authorized harman kardon service centre.
Problem Solution
If there is no sound from any of the speakers: Check that the receiver/amplifier is on and a source is playing.•
Make sure that all wires and connections between the receiver/amplifier and the speakers are •
connected properly.
Make sure none of the speaker wires is frayed, cut or punctured.•
Review the proper operation of your receiver/amplifier.•
If there is no sound coming from one speaker: Check that the balance control on your receiver/amplifier is not set all the way to one channel. •
Check your receiver/amplifier’s speaker setup procedure to make sure that he speaker in •
question has been enabled and its volume level has not been turned all the way down.
Make sure that all wires and connections between the receiver/amplifier and the speaker are •
connected properly.
Make sure the speaker wires are not frayed, cut or punctured.•
If there is no sound coming from the center speaker: Check your receiver/amplifier’s speaker setup procedure to make sure that the center speaker •
has been enabled and its volume level has not been turned all the way down.
Make sure that all wires and connections between the receiver/amplifier and the center speaker •
are connected properly.
Make sure the speaker wires are not frayed, cut or punctured.•
If your receiver is operating in Dolby•
®
Pro Logic
®
mode, make sure that the center speaker is not
set to Phantom.
You can find additional troubleshooting information in the FAQs link on the Support page at www.harmankardon.com.
HKTS 20+30+60 Service Manual
To Next Page
Loading...
