Harman Kardon PM655 Vxi - Page 10

OPERATIONS
Playback of an A/V Source
1.
2,
3.
Turn the VOLUME control knob to the minimum level and
press the POWER switch.
Set the SPEAKER selector for the desired speaker system(s).
Set the FUNCTION selector to the “A/V” position and the
A/V function indicator will light up.
Set the VCR/TAPE MONITOR selector to the “source”
position.
Activate the component connected to the A/V jacks.
Advance the VOLUME control knob to a comfortable level
and adjust the BASS and TREBLE control knobs as desired.
. Activate the BALANCE control knob, BASS TURNOVER,
TREBLE TURNOVER, TONE DEFEAT, PHASE-CORRECT
LOUDNESS, or MODE switches if necessary.
Recording from an Audio/Video Source
ile
Turn the VOLUME control knob to the minimum level and
press the POWER switch. The HIGH CURRENT indicator
lights up.
Set the SPEAKER selector for the desired speaker
system(s).
Set the FUNCTION switch to the “A/V” position.
Set the VCR/TAPE MONITOR selector to the “source”
position.
Set the RECORD OUT selector to the “source” position.
Advance the VOLUME control knob to a comfortable level.
Set the VCR (connected to the VCR/TAPE jacks) in re-
cording standby mode, following the owner’s manual of
the VCR.
Start the video player connected to the A/V jacks.
Recording begins by starting the VCR.
. Even if a tape deck is connected to the VCR/TAPE jacks,
audio programs can be recorded.
VCR Playback
the
wo
Turn the VOLUME control knob to the minimum level and
press the POWER switch. The HIGH CURRENT indicator
lights up.
Set the SPEAKER selector for the desired speaker system(s).
Set the RECORD OUT selector to the “off” position.
Set the VCR/TAPE MONITOR selector to the “1” or “2”
position corresponding to the VCR to be played. The 1 or
2 monitor indicator will light up.
. Insert a recorded video cassette in the VCR and set the
VCR in the playback mode.
. Advance the VOLUME control knob to a comfortable level
and adjust the BASS and TREBLE control knobs as desired.
. Activate the BALANCE control knob, BASS TURNOVER,
TREBLE TURNOVER, TONE DEFEAT, PHASE-CORRECT
LOUDNESS, HIGH CUT filter or MODE switches if nec-
essary.
Background Video
It is possible to watch a video source connected to the A/V
jacks on the monitor or television while listening to an audio
source connected to the PHONO, TUNER, CD or AUX jacks.
abs
as
Turn the VOLUME control knob to the minimum level and
press the POWER switch. The HIGH CURRENT indicator
lights up.
Set the SPEAKER selector for the desired speaker system(s).
Set the RECORD OUT selector to the “off” position.
Set the FUNCTION selector to a position other than the
“A/V” position.
. Set the VCR/TAPE MONITOR selector to the “source”
position.
Advance the VOLUME control knob to a comfortable level.
Start the video source (connected to the A/V jacks.)
Start the audio source (connected to the PHONO, TUNER,
CD or AUX Jacks).
. To record the selected audio/video program on the VCR,
set the RECORD OUT selector to the “source” position.
Copyright Information
Recording of copyrighted material for other than
personal use is illegal without permission of the co-
pyright holder.