STEP #1: PREPARE THE WORK AREA
Start by placing a drop cloth on the floor in front of your stove.
Alternatively you can use newspaper. Keep your tools on the drop
cloth so you can wrap them in it and take them outside for cleaning
when you are done.
STEP #1: REMOVE SOOT DEPOSITS FROM WITHIN THE BURN POT WITH THE VACUUM.
Remove the flame guide and vacuum the ash from the burn pot and above the burn pot (Fig. 2).
STEP #2: CLEAN THE BURN POT USING THE SCRAPER PROVIDED
Use the flat end of the scraper to remove the carbon from the burn pot (Fig. 3). Alternatively use a
hammer and a straight tip screw driver to tap the deposits loose.
When the burn pot has been
scraped, use a vacuum to remove the ash and carbon deposits.
Remove the ash pan from the stove (Fig. 4), dump out the ashes and clean out the interior and
exterior. Vacuum the lower area of the firebox while the ash pan is removed.
STEP #3: CLEAN ASH FROM INSIDE THE BURN POT
Remove the clean out plate under the burn pot by loosening
the two wing nuts holding the plate in place (Fig. 5). You
many need to use pliers to loosen the wing nuts initially and
then vacuum ash from the inside of the pot. Use your finger
to brush out any ash that can’t be reached with the nozzle of
the vacuum. After cleaning, be sure the plate is fully closed
before hand tightening the wing nuts.
(Note: You don’t
need to tighten the wing nuts with pliers.)
Fig. 2
Fig. 3 Fig. 4
Fig. 5
To Next Page
Loading...
Need help?
General
