Harman Infinity BassLink SM - Page 6

LIMIT UNIT
SPECIFICATIONS -- Infinity BassLink SM / JBL BassPro SL
All tests should be done with gain controls set so 1 volt in will give you ROP and
input switch should be set to low, power supply Voltage:DC=14.4V…… unless
other wise specified
Input Sensitivity
RCA input @ ROP Min Gain Volts
2Vac
Max Gain mV
200mVac
speaker level input @ ROP Min Gain Volts
20Vac
HI1=HI2 Max Gain mV
2Vac
Remote Bass level control
dB
0- -40dB
Gain Control THD Test
RCA input @ 1W Control @ MIN gain %
0.1%
Control @ 1V ROP %
0.1%
Control @ Max gain %
0.3%
speaker level input @1W Control @ Min gain %
0.1%
Control @ Max gain %
0.3%
Audio Turn on
Turn On
<
10mVac for 2
-
3S
Audio Turn on
Turn On
10mVac for 2 3S
Turn Off <5mV for 10 minutes
Input Voltage
Main High Vdc
16
Main Low Vdc
9
Remote High (Turn On) Vdc
4
Remote Low (Turn Off) Vdc
<4
Input Current
Main: 4 Ohm @ ROP A
<10A
Quiescent @ Pause mode A
<1A
Off mode @ Remote Off uA
10
Remote: standby mode @ Remote of
f
mA
10
efficiency 4 Ohm THD 1% %
>80%
Power/Protect - Auto Reset
DC on output Red LED
Yes
Speaker shor
t
1W, ROP
Red LED
Yes
Speaker shor
t
1W, ROP
Red LED
Yes
Speakersho
r
1W, ROP
Red LED
Yes
Low Voltage Red LED
Yes
High Voltage Red LED
Yes
Input Reversed Voltage fuse
Yes