The wireless subwoofer automatically connects with the soundbar when both units are powered on. If
the subwoofer is on and connected, the LED lights white continuously.
If no audio from the wireless subwoofer can be heard, manually pair the subwoofer:
1. Turn on the soundbar and the subwoofer. If the connection is lost, the LED indicator on the
subwoofer blinks slowly.
2. Press the CONNECT button on the subwoofer to enter pairing mode. The LED indicator on the
subwoofer blinks quickly.
3. Press and hold DIM DISPLAY button on remote control for 5 seconds, followed by short press on
BASS+, and BASSbutton in sequence. Panel display will show “PAIRING”
If the pairing succeeds, the LED indicator on the subwoofer lights up and the soundbar display will
show “DONE”.
If the pairing fails, the indicator on the subwoofer blinks slowly.
4. If the pairing fails, repeat the steps above.
4. PLACE YOUR SOUNDBAR
4a. Place the Soundbar on the table
4b. Wall mount the Soundbar
Use tape to stick the wall-mounted paper guide on the wall, push a pen tip through the center of each
mounting hole to mark the wall-mounted bracket location and remove the paper.
To Next Page
Loading...
