Harman P35I - Special Warnings and Notes; A. Carbon Monoxide Warnings & Considerations; B. Other Safety Considerations

5
3-90-774256_R4 • 03/21
Raised Hearth Installation
Whenconstructingwitharaisedhearth,besuretobuildinsupportforthecabinet.Thisoormaterialcanbeusedunderthe
cabinet only, or it can be applied onto the hearth as well. The image at right shows 3/4” plywood extending onto the hearth.
Notice the support members at the front and rear of the cabinet.
Thehearthnishmaterialcannotexceed1/4”abovethetopedgeofthecabinetbase.Seedetailbelow.Alsoremember,the
hearthneedstoextendtoprovidethepropercombustibleoorprotection.Figure7.
3/4” plywood decking
Support
Members
1/2” Finish Material
(Example)
Mantel must be a minimum of
12 inches above the cabinet top.
It is recommended to install 3/4”
plywood under the entire cabinet,
as a minimum for support.
Hearth nish material should be ush
with, or no more than 1/4” higher than the
top edge of the cabinet base. Exceeding
this height will prevent proper installation.
Ceramic Tile
(Example Only)
Figure 7
Framing leveling
bolts will fit here
Insert Mounting Frames securing holes
Mounting Frame Securing Points - Once framing
is complete secure the mounting frame into the ZC
box using 2” sheet metal screws proper installation.
Figure 5.