Harman XXV - Burn Pot Maintenance

26
XXV Pellet Stove
Options
Floor Protector
The Steel Floor Protector measures 32 inches
wide by 32 inches deep. This is the minimum size
foroorprotectionwiththisunit.Itismadeof20
gauge steel.
Direct Vent Wall Passthrough
The Harman Direct Vent Wall Passthrough makes
installing your Harman Pellet Stove with outside air
aloteasier.Itismadetotwallsfrom41/2"upto
10 1/8" thick with a square opening of 6" to 6 1/2".
Passthrough
hole for 3" PL
vent pipe
XXV Top Flue Option
The Top Flue option attaches to the exhaust on
the rear of the stove, and extends it to the top
with a six inch stub.
This gives the appearance of a wood stove and also
allows venting with existing single wall, connector.
A 12 inch piece of 4" pellet vent is included to act as
aninsulatoronly.Note:Thetopueadaptorisnot
approved for use with pellet pipe. It is only tested
for use with chimney connector (6- inch pipe) into
an existing "class A" chimney.
Harman Part #1-00-677120
Harman Part #1-00-677036
Harman Part #1-00-677077
Outdoor Half
Indoor Half
Adjustable from 4 1/2" to 10 5/8" wall thickness
This is used to
protecttheoor
under horizontal
pipe run.
Side View