Harman XXV - Manual Operation Modes; Manual Room Temperature Mode; Manual Stove Temperature Mode

Harman® •  Owners anualR2 • 200 - • 0812 1 3 -9 0 -0 0 6 8 4 c
F eeder Chamber
This chamber may get a buildup of nes from the feeder
mechanism movement. This area should be checked and
cleaned at least once a year.
To remove the feeder cover:
• Loosen the 51 wing nut. igure 5.8.
• Lift up and slide the cover off of the threaded stud.
• Inspect and clean the inner chamber if necessary igure
5..
• Reinstall the cover making certain it is seated properly on
the feeder body and tighten as tightly as you can by hand.
NOTE: V iews are shown with the rear motor covers
removed.
Pellet Metering
Slide Plate
e peet ne
buildup area.
F igure 5 .9
5 / 1 6 " W ing NutF eeder clean out cover
F igure 5 .8
G . Pellet F eeder Chamber