Title: PCM-1 to PCM-2 Upgrade Instructions Sheet 4 of 25 Rev: A Dwg: 873-4514-001
c. Select “SNMP Config”. If SNMP is being utilized then document this
information.
Figure 4
Port: _______________________
Protocol:____________________
RW Community: ______________
SNMP: _____________________
Trap IP 1:___________________
Trap IP 2:___________________
Trap IP 3: ___________________
Trap IP 4: ___________________
Trap IP 5: ___________________
d. Select the back arrow in the lower right hand corner and then select
“NTP Config". If NTP is being utilized then document this information.
Figure 5
NTP: ON or OFF
NTP Server IP 1:_______________
NTP Server IP 2:_______________
NTP Server IP 3:_______________
NTP Server IP 4:_______________
To Next Page
Loading...
