6-9
RF-7800W
SUPPORT DOCUMENTATION
f. Antennas for ETSI Compliance at 5.8 GHz:
This device has been designed to operate with the antennas listed in the following table, operating with
the maximum specified gain setting.
6.5 CHASSIS CONNECTOR DATA
Table 6-9 provides pin out data for the J6 connector.
FCC 5.725 - 5.850 GHz SPTP Operation
Model Number
Gain
(dBi)
Description
Max Tx Power (dBm)
5 MHz 10 MHz 20 MHz 40 MHz
RF-7800W-AT206 8 Omni 22 22 22 22
RF-7800W-AT207 14 90° 22 22 22 22
RF-7800W-AT201 21 10° 22 22 22 22
RF-7800W-AT202 26 6° 22 22 22 22
RF-7800W-AT203 30 4.4° 22 22 22 22
FCC 5.725 - 5.850 GHz SPMP Operation
Model Number
Gain
(dBi)
Description
Max Tx Power (dBm)
5 MHz 10 MHz 20 MHz 40 MHz
RF-7800W-AT206 8 Omni 22 22 22 22
RF-7800W-AT207 14 90° 19 19 19 19
ETSI 5.725 - 5.875 GHz Operation
Model Number
Gain
(dBi)
Description
Max Tx Power (dBm)
10 MHz 20 MHz
RF-7800W-AT206 8 Omni 22 22
RF-7800W-AT207 14 90° 19 22
RF-7800W-AT201 21 10° 12 15
RF-7800W-AT202 26 6° 7 10
RF-7800W-AT203 30 4.4° 3 6
Table 6-9. RF-7800W HCLOS Radio J6 Accessory Port
Pin # Signal Name Dir Description
A Accessory Tx/Rx+ I/O Per TIA/EIA-485
B Accessory Tx/Rx- I/O Per TIA/EIA-485
C Keyline O Floating, Active Low
D- N/CFuture Use
To Next Page
Loading...
