Harrison M250 - Page 29

Parts Ordering Procedure
TI
t2
Quote:
Machine Serial Number
which will be found stamped into the front
face of the bed ways at the tailstock end
Ref
er to the appropriate assembly and
Quote:
Individual Part Numbers taken direct from the Illustrations
NOTE: Quantity used (when other than one) is given in a circle following the Part
Number itself.
Where part numbers change with machine bed length then the model number is
given, vis.
I 500 I
or
~
Standard/ Proprietary Parts (i.e. items which can be purchased from local Engineering
suppliers) may be identified by the "bracketed" lett er code included in the Part Number,
and reference to the appendix at the end of this manual will provide a full description of
such items.
( __ P_a_rt_s_S_e_c_ti_o_n __ J
23