22
■ If the cuff has been applied firmly enough on the arm, the cuff symbol
appears on the display. If the cuff symbol does not appear on the display, the
cuff is not applied tightly enough and the error message ‘ ’ may also
appear on the display after a few seconds. Follow the instructions above as
described in 5.2 for applying the cuff as well as the information in Chapter 8
‘Explanation of error messages’ and repeat the measurement.
Important: please do not speak or move during the measurement.
■ Three short beeps indicate that the necessary inflation pressure has been
reached and that measurement is starting.
■ As the air pressure in the cuff decreases, the heart symbol flashes and the
dropping cuff pressure is displayed.
You can track the measurement progress using the progress bar. This
increases during the inflation phase and decreases in the measuring
phase. During the measuring phase, you will also see the symbols for
the two Duo Sensor Technology measuring methods. These indicate
that the sensors are functioning correctly. In addition, the heart symbol
shows your pulse, which is also measured.
■ A long beep indicates the end of measurement. After the measurement is
complete, the systolic and diastolic blood pressure as well as the pulse rate
(see Fig.) are shown on the display at the same time.
IFU_Veroval_dc_SK2_0307661_EN_TR_AE_CN_200918.indd 22 17.10.18 18:03
To Next Page
Loading...
Need help?
General
