26
If there is no morning or evening value for the last 7 days
in memory, dashes are shown on the display instead of
displaying the morning or evening average values. If no
values are stored at all in the memory, then dashes are
also displayed instead of overall average display values.
Individual measured values
■ By pressing the key (or the key if you are in user
memory 2) again, all saved values can be retrieved
one after the other, starting with the most recent
measurement.
■ If an irregular heatbeat or arrhythmia was detected during measurement,
that information is also stored and displayed when the measured value
is retrieved from the monitor's memory along with the systolic and diastolic
blood pressure readings, pulse rate, time and date.
■ The symbols , or (see Chapter 5.4) are also saved together
with the individual measurement if they were also displayed during the
measurement.
■ You can cancel the memory recall at any time by pressing the START/STOP
key . Otherwise, the device will switch off automatically after 30 seconds.
■ The saved values are still available even after the power supply is
interrupted, e.g. due to changing the batteries.
Deleting saved readings
All data saved for each user can be separately deleted for
user memory and user memory . Press the key for the
corresponding user memory ( or ). The average value ‘ ’
appears on the display. Now hold the user memory key for 4
seconds until the display starts to flash, apart from the symbols
and or . If you hold the memory key down for another 4
seconds, all data for the selected user memory will be deleted.
Dashes are shown instead of numerical values on the display.
IFU_Veroval_dc_SK2_0307661_EN_TR_AE_CN_200918.indd 26 17.10.18 18:03
To Next Page
Loading...
Need help?
General
