Harwin North America Harwin Europe Harwin Asia
T: +1 603 893 5376 T: +44 (0) 23 9231 4545 T: +65 6 779 4909
E: mis@harwin.com W: www.harwin.com E: mis@harwin.co.uk W: www.harwin.com E: mis@harwinasia.com W: www.harwin.com
IS-01 Issue: 9 Date: 27.04.2022 C/Order: 31490 Page 1 of 4
HAND CRIMP TOOL M22520/2-01
This Hand Crimp Tool has been designed for use with the following Crimp Contacts:
Datamate Signal Crimp Sockets (when used with Positioner T5747):
M80-01100XX .................. Large bore Female crimp contact for 22 AWG wire
(used in all L-Tek, J-Tek and Mix-Tek female crimp connectors).
M80-01300XX .................. Small bore Female crimp contact for 24-28 AWG wire
(used in all L-Tek, J-Tek and Mix-Tek female crimp connectors).
M80-01900XX .................. Extra small bore female crimp for 28-32 AWG wire
(used in all L-Tek, J-Tek and Mix-Tek female crimp connectors).
M83-01100XX...................Large bore Female crimp contact for 22 AWG wire
(used in all L-Tek, J-Tek and Mix-Tek female crimp connectors).
M83-01300XX..................Small bore Female crimp contact for 24-28 AWG wire
(used in all L-Tek, J-Tek and Mix-Tek female crimp connectors).
Datamate Signal Crimp Pins (when used with Positioner T5747):
M80-04000XX ................. Large bore Male crimp contact for 22 AWG wire
(used in L-Tek male crimp connectors).
M80-04100XX .................. Small bore Male crimp contact for 24-28 AWG wire
(used in L-Tek male crimp connectors).
Datamate Signal Crimp Pins (when used with Positioner Z80-193):
M80-19400XX .................. Large bore Male crimp contact for 22 AWG wire
(used in J-Tek and Mix-Tek male crimp connectors).
M80-19500XX .................. Small bore Male crimp contact for 24-28 AWG wire
(used in J-Tek and Mix-Tek male crimp connectors).
Datamate T-Contact Crimp Contact (when used with Positioner Z80-444):
M80-20600XX ................. 6 Finger Datamate Contact for 22 AWG
To Next Page
Need help?
General
