Hasselblad H3DII - Page 15

15
J
K
L
M
N
O
On the rear of the grip, as well as the rear control wheel, there are a further three
control buttons:
AE-L button J
is button can lock a light reading made in both automatic and manual exposure modes.
It can also be used in Zone mode to take a new reading.
Can be reassigned in Custom Settings to another function.
See section on the AE-L button (“Light Metering and Exposure Control”) for full de-
tails.
Card format button K
Re-formats the CF card. Purposefully recessed to prevent unintentional use. Dialogue
appears for conrmation.
USER button L
is button is purely user programmable to rapidly access a chosen function or screen.
For example, you might use bracketing a great deal and so by one press of this button
you could access the bracketing function without having to navigate through the menu.
e AE-L, Mirror -UP and Stop Down buttons are also user-programmable but are by default
initially assigned the functions according to their names
The reassignable capability of these buttons is particularly useful and can save you a
great deal of time and eort depending on how you work. You are advised to investi-
gate their potential fully. See under ‘Custom settings’ for full details.
On the front of the grip there are two more control buttons plus the remote cord
release port:
M.UP button M
Press this button to raise the mirror and press again to lower it (toggle function). A quick
double press of the button (two within a half second) will immediately access the ‘Self
timer’ function.
Can be reassigned in Custom Settings to another function.
Remote release cord port N
For attaching a remote release cord (electrical). e Hasselblad accessory jack plug socket
is protected by a captive rubber plug.
STOP DOWN button O
Press this button to make a visual check of the depth-of-eld on the viewnder screen at
the chosen aperture. e aperture will close according to the setting and remain closed
as long as the pressure is maintained. You can alter the aperture at the same time to see
the changes taking place.
Can be reassigned in Custom Settings to another function.