Hasselblad H4D-200 MS - Transferring Images

89
H4D
Tip
Use the delete shortcut immedi-
ately after an unwanted capture
to save space on a card.
Tip
One way of working is to simply assign unwanted images
as Red. In this way, you retain the option (for a while) of
changing your mind later while allowing the system to
automatically delete the unwanted images as the storage
medium fills up.
Note
You will always be asked to
confirm each delete operation.




3. Press  to open the Delete Image dialog.
4. You must now select the approval status that you wish to
delete. All images on the CF card that are also of the status
that you select here will be deleted by the operation.
Use  and  to select All Red, All Red & Yellow or All.
5. Then press  to open the delete dialog for the selected status.
You are now asked to confirm the delete.
6. • Toconrm,pressthe
+
button to change the status to Yes
and then press the OK button to execute the delete.
 • To cancel, press the menu button to exit; or press the
–
button to set the status to No and then press the OK button
to cancel.
You now return to the main menu. Either move on to another
setting by using the navigator button or
7. Press the menu (EXIT) button to exit the menu system.
Transferring images
Transferringtoacomputer
To transfer images stored on the compact-flash card to your
computer, simply connect the sensor unit to a computer using
a FireWire cable and then run Phocus. Alternatively, use a card
reader and connect to a computer. See the Phocus user manual
for details.
3
4
5
6 7