Camera
The Camera setting automatically corresponds to an H4D body
in normal use. However, when the sensor unit is attached to a
large format/view camera then other settings must be manually
made. See under SU-ViewCameras for further information.
About
Hasselblad regularly releases updates to the firmware of the
sensor unit. These updates not only improve the efficiency but
also often add new features. The About box will tell you which
firmware version is present so you can see if you have the latest
(which can be downloaded from the Hasselblad website). The
serial number is also displayed in case Hasselblad Support need
to know it for any eventual problem solving.
The About box also shows the focus calibration ID (which must
match the information on the grip display under System Status
to obtain the optimum performance). Each sensor unit is care-
fully adjusted to match the corresponding camera body, which in
turn produces the matching verifications respectively. If you want
to use different sensor units with different camera bodies, please
refer to a 'Hasselblad Service Center' for more information.
To obtain the About information:
1. Select MAIN MENU > SETTINGS > ABOUT.
2. Press to open the About dialog, which shows the serial
number and firmware version. When you are done reading
the information, press the menu (EXIT) button to return to
the SETTINGS menu. Either move on to another setting by
using the navigator button or press the menu (EXIT) button
again to exit the menu system.
Default
The DEFAULT setting will reset all custom settings you have
made back to the original default / factory settings.
To reset all settings:
1. Select MAIN MENU > SETTINGS > DEFAULT.
2. Press the OK button and then the EXIT to return.
1
2
1
2
To Next Page
Loading...
