EPA CERTIFIED ENGINES 2L41C, 2M41, 2M41Z
104
HATZ
Operator’s Manual
▪ In order to obtain service under this warranty, the retail purchaser should
contact Hatz Diesel of America, Inc. at (262)-544-0254 for information and
the nearest service center. The retail purchaser will not be charged for di-
agnostic labor which leads to the determination that a warranted part is
defective, nor for the repair or replacement of warranted parts if the work is
performed at an authorized Hatz service center. If other engine compo-
nents are damaged due to a failure of the above-listed warranted parts still
under warranty, these other engine components will also be repaired or re-
placed at no charge.
▪ This warranty shall not apply to any engine which shall have been installed
or operated in a manner not recommended by Hatz, nor to any engine
which shall have been repaired, altered, neglected, or used in any way
which, in the opinion of Hatz, adversely affects its performance, nor to any
engine in which parts not authorized by Hatz have been used, which parts
or the use of which have damaged or caused defects in or otherwise ad-
versely affected the engine or its performance, nor to normal maintenance
service or replacement of normal service items.
Hatz reserves the right to modify, alter, and improve any engine or parts
without incurring any obligation to replace any engine or parts previously
sold with such modified, altered, or improved engine or parts.
EMISSION-RELATED INSTALLATION INSTRUCTIONS
“Failing to follow these instructions when installing a certified engine in a
piece of nonroad equipment violates federal law (40CFR1068.105(b)), sub-
ject to fines or other penalties as described in the Clean Air Act.”
“If you install the engine in a way that makes the engine's emission control
information labels hard to read during normal engine maintenance, you must
place duplicate labels on the equipment.”
EQUIPMENT-LABELLING REQUIREMENTS: FUEL LABEL (see chapter 3.3
Labels, page 20)
The fuel label has to be permanently attached to the equipment.
In case of an engine mounted fuel tank, every engine is equipped with an
additional fuel label nearby the fuel inlet.
Otherwise, there are two loose fuel labels available with the engine.
If the original fuel label is not readily visible after the engine is installed in the
equipment then the second loose fuel label must be attached on the equip-
ment in such a manner that it is readily visible to an average person.
To Next Page
Loading...
