88 4001001030 E 06.20 USA / GB
D- Operation instructions
Compact 8 (C 2032E) - Compact 8W (C 2047E) - Compact 10 (C 2747E) - Compact 10N (C 2632E) -
Compact 10N-1 - Compact 12 (C 3347E) - Compact 14 (C 3947E)
5.8 - L
IFTING
OPERATION
Before any lifting operation, it is necessary to take into account the following points :
Do not operate machine unless you have :
• been fully trained and are qualified in proper operation.
• read and understood the information in the Operator's manual of the machine.
5.8.1 - Safety precautions
It is the responsibility of the Operator to ensure there are no personnel or obstructions to safely
perform the operation.
5.8.2 - Preliminary procedures
• Inspect the surrounding area and position the machine at a safe distance from electrically
charged conductors to ensure that no part of the machine is within an unsafe area. Always
stay clear of overhead obstructions.
• Respect the local rules and the minimum safe distance from power lines.
• Stop the machine.
• Remove the ignition key.
• Ensure that the main power is disconnected.
• Place a "DO NOT USE" decal near the start/stop switches to inform personnel that machine
is not operational during the lifting process.
• Cordon off the area surrounding the machine to keep personnel, vehicles and moving
equipment away from the machine.
• Remove all loose items from the machine.
• Ensure that vehicle capacity of the forklift and lifting equipment - hoists, slings, straps, etc.
are of sufficient strength to withstand maximum machine weight.
• Attach the rigging ONLY to the designated lifting points on the machine.
ONLY trained and authorized personnel should attempt to lift the machine.
To Next Page
Loading...
