Haulotte HA20RTJ - Automatic Regeneration; Manual Regeneration; To Inhibit Regeneration

A
B
C
D
E
F
G
H
I
63
4000715370
E 06.18 - V2
USA / GB
HA20RTJ - HA20RTJ O - HA20RTJ PRO - HA61RTJ O - HA61RTJ PRO
B - Familiarization
4 different ways of regeneration are possible.
3.4.1 - Automatic regeneration
The automatic regeneration occurs during normal machine usage without any interruption.
When automatic regeneration is on-going : :
1. icon lights up on ground control box.
2. DPF disable icon HL302 / LED107 on the platform control box display lights up.
3.4.2 - Manual regeneration
1. Park the machine in a safe stowed position outside location and away from other
equipment.
2. Check that the fuel level icon on the ground control box doesn't light-up.
3. Put the engine hood in closed position.
4. Press the regeneration button on the ground control box and hold for 5 seconds.
5. When regeneration is initiated, the regeneration icon on the ground control box
starts blinking.
6. Engine speed increases to 2300 rpm.
7. The regeneration cycle will take approximately 15 min.
8. When regeneration is complete, all engine lights on the
ground control box are turned off. Engine speed is automatically decreased to idle speed
(1500 rpm).
3.4.3 - To inhibit regeneration
To inhibit regeneration (indoors or in explosive atmosphere), press button on ground
control box and hold for 5 seconds. The regeneration is inhibited until cancellation. To activate
regeneration, press the button again during 5 seconds. When the regeneration is
inhibited, at ground control box and at platform control box display light up.
The machine cannot be used during the manual regeneration cycle.