245 4001055180 E 06.21 USA / GB
Turntable
Remove/re-install the covers
MS0151
Turntable
Remove/re-install the covers
1 - You will need
2 - Preliminary operation
The operations of disassembling if they exist should be carried out only on the installations completely disconnected
and must be entrusted only to people having the necessary technical training.
Respect, in addition to the instructions appearing in the present instructions, the legal tendencies generally applicable
for safety accident prevention.
All the precautions must be done in work before intervening on and near the machine.
After completion of work, all the covers and safety devices must be positioned back completely and operational.
• The worker must make sure to have the EPI (Personal Protective Equipment) suited to the work and to the
environment's specific conditions in which the equipment is located (see safety information specific to the work site.
• Position the machine on a flat and firm surface, clear of obstructions (beware of power lines).
• Mark out the work area.
• Switch off the ignition and remove the ignition key.
• Put a "DO NOT USE" decal near the start/stop button to inform personnel that work is currently in progress on the
equipment.
• Beware of the risk of burns; the hydraulic system operates at high temperatures.
• The pressure in the hydraulic system is very important. It can cause accidents. Relieve the pressure before
beginning any work and never search for oil leaks using your hands.
• Engine exhaust gases contain harmful products of combustion. Always start and run the engine in a well-ventilated
area. In a closed room, ensure the exhaust gases are evacuated to the outside.
• Standard tool kit
• Protective goggles
• Gloves
• EPI (Personal protective equipment)
• 2 hoisting strap(s) for 1000 kg / 2,205 lbs at a length of
4 m / 13 ft 13 in
• Lifting and handling equipment(bridge crane, crane, etc)
• Place barriers around the perimeter of the work area
2
To Next Page
Loading...
