3
Read instruction manual before operating and observe all warning.
WARNING:
DO NOT aim sprayer at yourself or anyone else at all times, in the event of an injury
occurring seek expert medical consultant immediately.
DO NOT allow any part of the body to come in contact with the fluid stream.
DO NOT cover the nozzle with any part of your body, high velocity jet could cause
accidental injuries.
DO NOT spray any hazardous materials (for example: easy flammable, very toxic, toxic,
less toxic, corrosive or irritating substances).
DO NOT spray any textured materials containing particles or fibers such as asbestos
fibers.
DO NOT spray flammable liquid.
DO NOT clean guns with flammable solvents.
DO NOT spray any material where the hazard is not known.
DO NOT use the spray gun outside when it is raining to reduce the risk of electric shock.
DO NOT use the spray gun at any stuffy area. Ensure adequate ventilation at all time when
using the unit.
DO NOT disassemble the sprayer without skill’s direction for avoiding danger.
DO NOT tamper with electrical motor, switch wiring or plug.
DO NOT leave your sprayer unclean or allow paint to dry in the gun. An unclean sprayer
will not work next time and you could void the one-year warranty.
DO NOT use the power tool if the switch does not turn it on and off.
NEVER immerse the sprayer into water or other liquids for preventing electric shock.
ALWAYS place the sprayer upright (do not place the sprayer upside down or on its side) to
prevent liquid or paints flow into motor.
ALWAYS wear mask, goggles, ear protectors and eye protectors while operating the
sprayer.
ALWAYS unplug the cord to prevent accidental spraying when you stop spraying or
servicing.
ALWAYS keep children and bystanders away.
USE fluids with a flashpoint above 40 degrees C.
To Next Page