Power supply of driving recorder
73D3F11BEA63
It is located near the inside rearview mirror.
This power supply can be used when the vehicle
power is in the ON position.
Notice
Due to different vehicle configurations, the
power outlet of the event data recorder may
be installed on the right side of the interior
mirror. Please refer to the actual vehicle.
This power supply is designed to provide a 5 V
DC power for driving recorders rated less than
or equal to 10 W.
⚠ Warning
For driving safety, be careful not to block the
line of sight to prevent danger when installing
a driving recorder.
⚠ Warning
Inflammable gas and heat sources should be
kept away from power sockets.
⚠ Caution
Do not allow liquids such as drinks or
foreign matter to enter power supply
sockets; otherwise, a short-circuit or other
fault could easily occur. If the power supply
socket has a protective cover, replace the
protective cover when not in use.
If you use an accessory which exceeds the
power rating, you may blow a vehicle fuse.
Do not connect precision devices, strongly
inductive devices, or other important device
to this power supply socket.
Do not use this power supply in damp or
high temperature conditions.
Do not connect in parallel or series with any
other power supply.
If any abnormality occurs during use
(abnormally high temperature, smoke,
odors, etc.), please immediately stop usage
and go to an authorized service center as
soon as possible for repair.
Unauthorized customization or repair of this
power supply system is prohibited.
Pay attention to waterproof and sealing
when connecting the external cable harne.
To Next Page
Loading...
