Power battery vent
There is an air intake vent under the rear seat
for cooling the power battery. If the air inlet is
blocked after the vehicle is started, the power
battery will overheat. To protect the power
battery, the system may limit the discharge
/charging of the power battery.
A5E709527305
Notice
Clean the vent regularly to prevent the
power battery from overheating.
Do not place foreign matters near the vent;
otherwise, the power battery may overheat
and be damaged.
Prevent foreign matters or water from
entering the vent; otherwise, a short circuit
may occur and the power battery may be
damaged.
Energy recovery
The main purpose of this function is to convert
part of the kinetic energy from braking or
movement into electrical energy for the power
battery. This extends the vehicle's range.
The energy recovery level can be set via
[vehicle setting]→[driving] on the multimedia
display screen.
Notice
When one pedal mode is on, the energy
recovery level is not adjustable.
⚠ Warning
The decrease in vehicle speed caused by
energy recovery cannot take the place of
normal braking. To decelerate and stop the
vehicle, you must press on the brake pedal.
Notice
When energy recovery is activated, causing
significant deceleration, the brake lights can
come on.
Notice
Energy recovery will not take place under the
following circumstances.
When the vehicle is in gear N.
When the power battery is fully charged.
When the temperature of the power battery
is too high or too low.
Battery safety switch
BD8755231D9A
The battery safety switch under the luggage
compartment is used to disconnect or connect
the power supply of the high voltage system,
which can be seen after removing the trunk
cover plate and cover tray.
To Next Page
Loading...
