ZEB Horizon ZEB Cam Firefly 8S Reset
Overview
This article explains how to reset the ZEB Cam for ZEB Horizon - Firefly model 8S.
Note: Please check your camera model first to make sure you are following the correct procedure. If you're not sure
which ZEB Cam version you have, check out this article first: Identifying ZEB Cam Model on ZEB Horizon.
Procedure
1. Remove the camera from the scan head by unscrewing the 4 retaining screws using T20 Torx screwdriver.
https://knowledge.faro.com/Hardware/GeoSlam/ZEB_Accessories/ZEB_Horizon_ZEB_Cam_Firefly_8S_Reset
Updated: Wed, 11 Oct 2023 12:21:09 GMT
1
To Next Page
