Need help?Do you have a question about the Hawking 100M and is the answer not in the manual?
Interfaces| network interface ports | 16 * 10/100/1000Mbps auto MDI/MDI-X RJ-45 |
|---|---|
| console port | 1 * RS-232 |
Cable Connections| cable type for 10BASE-T | Category 3, 4, 5 UTP/STP |
|---|---|
| cable type for 100BASE-TX | Category 5 UTP/STP |
| cable type for 1000BASE-T | Category 5, 5e or enhanced UTP/STP |
Network Data Rate and Transmission Mode| network data rate | 10/100/1000Mbps Auto-negotiation |
|---|---|
| transmission mode for 10/100Mbps | Full-duplex, Half-duplex |
| transmission mode for 1000Mbps | Full-duplex |
Memory| mac address table | 4K MAC entries |
|---|---|
| buffer memory | 272K |
Operating Environment| operating temperature | 0°C ~ 50°C (32°F ~ 122°F) |
|---|---|
| operating humidity | 10% - 90% |
Power Supply| power supply type | Internal power supply |
|---|---|
| voltage range | 100-240V |
| frequency range | 50-60Hz |
Overview of the 16-port Web-Smart Switch functionality and benefits.
Explanation of Gigabit Ethernet standards and performance improvements.
Lists the primary features and capabilities of the HGS16S switch.
Description of the switch's front panel layout and indicators.
Details on the rear panel connectors and power input.
Instructions for placing and setting up the switch on a desk.
Guide for securely mounting the switch into a standard equipment rack.
Procedures for connecting network cables to the switch ports.
Diagram illustrating a typical network configuration with the switch.
How to monitor switch ports and configure operational modes.
Explanation of the flow control feature for traffic management.
Functionality of MAC address aging for table maintenance.
Configuration of static VLANs for network segmentation.
Setup and use of port aggregation for increased bandwidth.
Configuration of QoS for traffic prioritization using TOS.
Methods for accessing the switch management interface via console or network.
Overview of the switch's web interface homepage and its configuration tabs.
Configuration of system settings, including IP, login, and timeouts.
Detailed management of switch ports, speed, and flow control.
Advanced VLAN configuration, including entries and PVID settings.
Setup for port trunking groups and aggregation modes.
Configuration of Quality of Service parameters for traffic priority.
Setting up port mirroring for traffic analysis.
Viewing port traffic statistics and network performance data.
Using the discovery tool to locate and access switches on the network.
Procedure for restoring the switch to its factory default configuration.
Instructions for performing a warm restart of the switch.
To Next Page
