EasyManua.ls Logo

Hayward Pool Products HeatPro HP21104T Installation Guide

Default Icon
21 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
HP13023770 Rev: F
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Pomona, CA Clemmons, NC Nashville, TN
Tel: 908.351.5400 www.haywardpool.com
Models: HP20654T, HP20654BT, HP20854T,
HP20854BT and HP21104T
INSTALLATION GUIDE
SAVE THIS INSTALLATION GUIDE
Basic safety precautions should always be followed, including the following: Failure to follow instructions can cause severe
injury and/or death.
This is the safety-alert symbol. When you see this symbol on your equipment or in this manual, look for one of the following
signal words and be alert to the potential for personal injury.
WARNING warns about hazards that could cause serious personal injury, death or major property damage and if
ignored presents a potential hazard.
CAUTION warns about hazards that will or can cause minor or moderate personal injury and/or property damage
and if ignored presents a potential hazard. It can also make consumers aware of actions that are unpredictable and unsafe.
The NOTICE label indicates special instructions that are important but not related to hazards.
The Hayward HeatPro Heat Pump is listed by ETL as complying with the latest edition of the “UL Standard for Safety for
Heating and Cooling Equipment”, UL1995 and CSA C22.2 No. 236.
All Hayward HeatPro Heat Pumps must be installed in accordance with all applicable National and Local codes. In the absence
of local codes, refer to the latest edition of the National Electric Code (NEC) in the United States and the Canadian Electric
Code (CEC) in Canada
Important Information to
keep for Service
Model # ________________
Serial # ____________________
Install Date _________________

Other manuals for Hayward Pool Products HeatPro HP21104T

Questions and Answers:

Hayward Pool Products HeatPro HP21104T Specifications

General IconGeneral
ModelHP21104T
TypeHeat Pump
Heating Capacity110, 000 BTU/hr
Voltage208/230V
Phase1
Hertz60 Hz
RefrigerantR410A
CompressorScroll
Heat ExchangerTitanium
Warranty2 years
Water Flow Rate30 - 70 GPM
Maximum Breaker Size50 Amps
Pipe Size2"
Ambient Operating Temperature Range104°F

Related product manuals