Cleaner falls on its side.
Takes long time to recover
if on its side.
• Check the Leader Hose for float placement. The float may be in the
wrong position.
• Check that the hose is long enough to reach the furthest point in
the pool.
• Check the direction of the return line water flow. If it is interfering
with the path of the cleaner, redirect to a different direction.
The left track wheel skips
teeth when rotated forward
by hand (looking from the
front).
• Wheel hub or right drive shaft gear worn/damaged.
The loops in the hoses
won’t come out.
• Do not store hose in coiled position.
• Lay hose straight and in sunlight.
• Clean swivel on turbine. Reposition leaf canister if installed. It may
be in wrong position or not floating.
• Total length of hose too long for your pool configuration.
The cleaner turns in
circles, it won’t go straight
at all.
• Wheel hub and/or long drive shaft gear and/or steering slide as-
sembly and/or left drive gear are worn or damaged.
The cleaner does not clean
the entire pool.
• The hose is too short.
• The float may be in the wrong position on Leader Hose. Verify that it
is 20-24” from cleaner head.
• Clean swivel on turbine.
• Check the direction of the return line water flow. If it is interfering
with the path of the cleaner, redirect to a different direction.
If cleaner is behaving er-
ratically while installed on
pool with solar heating.
• Operate suction cleaner and solar heating on alternating schedules.
Remove TracVac when not in use on these type of pools.
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
10
To Next Page
Loading...
Need help?
General