Need help?Do you have a question about the HBM Machines HBM 250 and is the answer not in the manual?
This warranty is null and void in case of defects occurring due to the following causes.
To use your right to warranty you should send the machinery or its part to us, postage paid.
It's impossible to enumerate all possible uses for which a given product is NOT suited.
Only well trained personnel is allowed to operate this machine.
BEWARE! Please wear anti slip footwear. If your hair is long, put it under your clothes.
Please check if the product arrives (1) without damage and (2) complete see the parts list or packing list.
Heavy products are here defined as products weighing over 25 kilograms.
Description of the lathe bed structure and its components.
Details about the headstock construction, function, and gearbox.
Description of the carriage, apron, leadscrew, and tailstock.
Explanation of change-over, emergency, and ON/OFF switches.
Details on feed direction and rate selectors.
Operation of compound, cross slide, and carriage locks.
Guidelines for tool setup, chuck replacement, and speed adjustments.
Methods for straight turning, facing, and turning between centers.
Techniques for taper turning and thread cutting.
Description and usage of the universal three-jaw and four-jaw chucks.
Information on drill chuck, Morse taper arbor, and live center.
Procedure for adjusting main spindle bearings.
How to adjust cross slide, top slide, and half nut guide.
Instructions for lubricating the gearbox, gears, carriage, slides, and apron.
Lubrication for leadscrew and tailstock.
Schematic for connecting the lathe to the mains supply with safety warnings.
Guidelines for keeping the machine in good working order.
Safe methods for chip removal and cleaning.
List of parts for the headstock and drive system.
Component breakdown of the lathe gearbox.
Component listing for the lathe apron.
General| Voltage | 400 V |
|---|---|
| Maximum drilling capacity in steel | 25 mm |
| Maximum milling capacity face milling | 63 mm |
| Maximum milling capacity end milling | 20 mm |
| Spindle taper | MT3 |
| X-axis travel | 500 mm |
| Spindle holder | MT3 |
| T-slots | 14 mm |
To Next Page