EasyManua.ls Logo

HBX Onslaught - Getting Familiarized With Your 2.4 GHz Radio System

HBX Onslaught
25 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
GETTING FAMILIARIZED WITH YOUR 2.4GHz RADIO SYSTEM
3
1) Steering Wheel
2) Trigger
3) Steering Trim
4) Throttle Trim
5) Steering Reverse Switch
6) Power Indicator
7) Power ON/OFF
8) AUX. Button
(This button is disabled for
the car)
1
2
4
7
6
3
5
8
Steering Wheel: It proportionally operate the right and left steering control of the model.
Battery Case: It requires 2pcs of AA size batteries.
Power Switch: It is applied to turn ON/OFF the radio controller.
Steering Trim: It is applied to adjust the centre trim of the steering channel.
Steering Reverse: It allows you to switch the directions of the steering servo travel.
Power Indicator:
When the radio controller is turned on, LED flashes sharply which indicates that the radio
controller is seeking the receiver's signal and binding is in process.
When the power is enough, LED is solid on.
When the power is not enough, LED will have two flashes in turn. If it is the case, you are
required to replace with the new batteries.
1) Do NOT mix new and old batteries.
2) Use batteries of same brand.
3) Do NOT use batteries that are not allowed to power the radio controller.
(This radio controller ONLY requires AA size batteries which is individually 1.5V)
4) Always remove the batteries from the radio controller if the radio controller is not in use.
This operation is to prevent the damage from leaking batteries.
5) Do not attempt to disassemble the radio controller as it contains many electronic components.
Slide the battery cover as shown in the
photos, install two AA size batteries into
the battery compartment, and replace the
battery cover.
( NOTE: Do not insert the batteries with
incorrect polarities.)
Operation Precautions:

Related product manuals