User's Guide
Getting Started
Powering ON the Notebook PC
The Notebook PC's power-ON message appears on the screen when you turn it ON. If you need to run
the BIOS Setup to set or modify the system configuration, press (F2) upon boot up to enter the BIOS
Setup.
Important :
To protect the hard disk drive, always wait at least 5 seconds after turning OFF your Notebook PC before
turning it back ON.
Note :
Before bootup, the display panel flashes when the power is turned ON. This is part of the Notebook PC's test
routine and is not a problem with the display.
3-6
To Next Page
Loading...
