QUICK START GUIDE
FULL MANUAL ON SUPPORT.HDANYWHERE.COM
1
Connect a HDMI source device (e.g Satellite/Cable TV, Apple TV, Blu-ray, DVD
etc) to one of the ports labelled “SOURCE INPUT” on the MHUB chassis using
a good quality HDMI cable.
The steps below describe how to connect a single HDMI source to a display location for outputs 1-3 and enable remote control (IR) signals to be sent from that location back to your
MHUB chassis. If you want to setup IR control on output 4, please refer to the product manual. Repeat the steps below as necessary for each source or display.
2
Connect a CAT cable between one of the HDBaseT output ports (labelled A, B,
C) on the MHUB chassis, and the “HDBASET” port on the MHUB receiver.
3
Connect a HDMI cable between the port labelled “HDMI OUT” on the MHUB
receiver and a HDMI port on your display. Ensure that your display is switched
to the correct input. Note: MHUB receivers do not need any power cables to
work, power is delivered from the MHUB chassis. Check the white LED light on
the MHUB receiver is lit, this indicates a connection with the MHUB chassis.
Check that you are receiving a picture on the connected display.
4
6
5
To control your HDMI source from your display location, connect an IR TX to the
“SOURCE IR (OUT)” port on the MHUB chassis, that matches the “SOURCE
INPUT” port number for the source you want to control. Connect an IR RX to the
“IR (IN)” port on the MHUB receiver.
Test the IR control is working by using the source device remote pointed
towards the IR receiver at your display location.
Connect the “HUB CONTROL IP” port to your router via an ethernet cable. You
can then download our uControl app which is available for iOS and Android. The
uControl App will also provide your MHUB IP address.
HDMI CABLE
CAT6 CABLE
INFRARED (IR) CABLE
NETWORK CABLE
POWER
1
6
2
3
4
5
CAT6 RESOLUTION/DISTANCE GUIDE
0m
0ft
10m
32ft
20m
65ft
30m
98ft
40m
131ft
50m
164ft
60m
197ft
70m
230ft
HD UHD
IN THE BOX
1x IEC POWER CABLE + 24V PSU
1x MHUB 4K (4X3+1) CHASSIS
3x MHUB RECEIVERS + 6x MOUNTING WINGS
1x REMOTE CONTROL
INFRARED (IR) CABLES
2x CHASSIS
MOUNTING BRACKETS
4x IR RX
4x IR TX
INPUTS
OUTPUTS
menu
1 2
3 4
A
ALL
CLEAR OK
EDID
B
C D
1
2
3
4
A
1
2
3
4
B
1
2
3
4
C
1
2
3
4
D
1
2
3
4
A
1
2
3
4
B
1
2
3
4
C
1
2
3
4
D
To Next Page
Need help?
General
