they do not pair with your device properly, reset the headphones
as instructed later in this manual.
2.3 Usage method
To turn them on or off, long press
the multifunction button on either
side of the headphones for 5
Press the multifunctional button on
either side of the headphones once.
To increase the volume, double-
press the right side multifunctional
button.
To decrease the volume, double-tap
the left side multifunctional button.
song
To play the previous song, press
and hold the multifunction button
on the left side for 2 seconds.
To play the next song, press and
hold the multifunction button on the
right side for 2 seconds.
calls
To answer or hang up a call, press
the multifunction button on either
To reject an incoming call, double-
press the multifunction button on
either side of the headphones.
To activate voice assistants, press
the multifunctional button on the
2.4 Charging the headphones
These headphones incorporate a USB-A to 4 pins charging cable.
Connect the cable that is included in the package to a wall charger,
power bank or computer output.
It takes about 2 hours to charge the headphones up to full.
Troubleshooting: If the headphones LED indicator does not turn on
during its charge, it should be due to a power supply issue. Please,
check if the charging cable is correctly connected. Check both ends
of the cable, as well as the power supply state and the device you
are using to charge, whether it is a wall charger, a power bank or a
PC port.
2.5 How to use the internal memory
Connect the charging cable to the headphones’ charging port, and
plug the USB-A into the computer's USB port. Now the headphone
is connected to the computer for storage reading. Copy the music
files and paste them into the headphone storage drive. Now click
"Safely Remove Hardware" at the bottom right corner of your
computer, select "Eject USB Device" and unplug the charging cable.
2.6 How to pair the headphones with 2 smartphones
Unpair the headphones from device A. Connect the BT from device
B and pair the headphones with device B. Now connect the BT from
device A and pair the headphones with device A.
3. Safety, maintenance and usage recommendations
Read all documentation and instructions provided before using the
product. Use only accessories compatible with the product. Clean
the product regularly with a dry cloth. The product must be
unplugged or switched off when cleaning. Keep the product's ports
and connectors clean from dust, dirt, etc., to ensure proper
connection. Avoid breaking the product. Do not apply excessive
pressure to any part of the product. If the product has a cable, do
not bend it and do not pull it with excessive force to avoid damaging
it. Do not expose the product to a higher level of humidity than it
was designed for. If the product is resistant to liquids, after any
immersion or use in liquids, rinse the product with fresh water and
dry it. Always keep the product in a dry place away from moisture.
Always keep the product away from flammable materials and do
not expose it to fire, heat sources or extreme temperatures. When
the product is not in use, unplug it and store it in a clean, dry place
away from moisture and dirt. If water enters the product,
immediately disconnect it from any power source or device to
which it is connected. Do not use the product for any purpose other
than that for which it was designed. Do not use the product if you
To Next Page
Loading...