- 3 -
5. Frequently Asked Questions
Please read our iQSE FAQ before sending a question:
http://www.healtech-electronics.com/app/iqse/faq_en
6. Troubleshooting
In case of problems or concerns, please check out our Troubleshooting Guide:
http://www.healtech-electronics.com/app/iqse/trb_en
7. LED status codes
Solid RED Unit is powered up.
Engine is not running or RPM signal is not received.
Solid GREEN Unit is powered up.
Engine is running (RPM signal is received).
Flashing RED Error detected.
Connect to the application to see the problem.
Flashing GREEN Bluetooth interface is in standby (typically, while riding).
Cycle the ignition key if you wish to connect.
Alternating color Shift signal detected, data is sent to the module or firmware
update is in progress.
8. Warranty
Disclaimer: Do not attempt to install the product if you don’t have basic
mechanical skills. HealTech Electronics Ltd. and its distributors shall not be
liable for any loss or damage caused by improper installation or setup. Please
read the instructions carefully.
If the gearshifts are not smooth, do not stress your gearbox. Use the clutch
until you make the necessary changes.
To ensure trouble-free operation from the start, all units have been extensively
tested prior to shipment. For this reason, please make sure you followed the
install steps carefully and check the connections and settings before you report
a problem.
The product is covered by our 2-year replacement warranty from the date of
purchase.
The warranty does not apply to product that has been subjected to misuse,
fitted incorrectly or there’s a visible damage e.g. from a crash.
Web: www.healtech-electronics.com
Email: support@healtech-electronics.com
To Previous Page
Loading...
Need help?
General