EasyManua.ls Logo

HealthTool EatSmart ESBS-01 User Manual

HealthTool EatSmart ESBS-01
4 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Question and Answer IconNeed help?

Do you have a question about the HealthTool EatSmart ESBS-01 and is the answer not in the manual?

HealthTool EatSmart ESBS-01 Specifications

General IconGeneral
TypeDigital Bathroom Scale
DisplayLCD
Auto CalibrationYes
Auto Power OffYes
MaterialTempered Glass
Weight Capacity400 lbs (180 kg)
Units of Measurelb, kg, st
Power Source4 x AAA batteries
Weight Increments0.2 lbs (0.1 kg)

Summary

Troubleshooting

Scale is inaccurate or weight varies

Ensure proper foot placement and stillness on the scale; allow auto-shutoff to prevent unnecessary movement.

First weight is higher than normal

The scale requires auto-calibration on a hard, flat surface for accurate initial readings.

Scale displays 'ERR'

Place the scale on a hard, flat surface and allow it to shut off and restart to resolve.

Low battery indicated 'LO' / No power

Check battery installation for correct polarity and replace all four batteries if worn.

Overload indicated 'O LD'

The scale has exceeded its capacity; remove weight before proceeding with measurements.

Other conditions

Contact HealthTools for support if issues persist.

Care and Maintenance

Storage and Operating Environment

Store and operate the unit in a safe, dry location, avoiding direct sunlight, extreme temperatures, or humidity.

Cleaning Instructions

Clean with a soft, damp cloth; avoid abrasive cleaners and do not submerge the scale in water.

Battery Removal for Long Storage

Remove batteries if the unit will not be used for three months or longer.

Consistent Unit Usage

Use the unit consistently according to the instructions provided in this manual.

Introduction

Product Package Contents

Your EatSmart Bathroom Scale includes the scale, instruction manual, and 4 AAA batteries.

Warranty Information

Includes a 2 Year EatSmart Guarantee covering defects under normal use.

Operation

Battery Installation and First Time Setup

Install 4 AAA batteries, then auto-calibrate the scale on a hard, flat surface before first use.

Weighing Operation

Select units, place scale on a hard surface, and step on for accurate weight measurement.