6
INSTALLING A NEW BLADE
11. Once the wheel covers have been raised,
slip the blade off of both wheels and
carefully remove the blade from the saw.
1. Once the old blade has been removed
the new blade can be installed. Place the
blade around the Drive and Idle Wheels
with the blade teeth facing outward.
NOTICE!!!! Be careful when handling saw
blades so that the tooth edge is not damaged.
A chipped or broken tooth will cause cutting
problems.
2. If Guide Caps have been removed to
clean the Blade Guides, replace the Guide
Caps but leave them loose enough to be
enable sliding the blade up between the
Carbide Blade Guides.
To Next Page