1
Hearth & Home Technologies • STPR-MOD-KIT Contemporary Kit Instructions • 2488-971 Rev. F • 3/22
TOOLS
Screw gun equipped with 1/4 in. socket or
1/4 in. wrench
3/8 in. wrench (Propane Appliances Only)
Instructions for optional glass kit, if applicable.
Leave this manual with party responsible for use
and operation.
STPR-MOD-KIT
Models: PIER-36TRB-IFT, ST-36TRB-IFT, ST-DV36IN, PIER-DV36IN, GDFL4136IFT, GDST4336IFT
Installation Instructions
CAUTION! Do not install damaged components.
DANGER
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
A barrier designed to reduce the risk of
burns from the hot viewing glass is provided
with this appliance and must be installed for
the protection of children and other at-risk
individuals.
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
WARNING! Choking Hazard! Keep media and stones
out of reach of children.
Note: If an optional LINER-36ST or LINER-36PIER kit
will be used with the STPR-MOD-KIT, the LINER-36ST/
LINER-36PIER instructions will be needed during instal-
lation of the STPR-MOD-KIT.
Note: The STPR-MOD-KIT is not compatible with ber
refractory.
WARNING! Risk of Injury! This kit must be installed by
a qualied service technician.
Note: The control module MUST be set to 30%
turndown when the STPR-MOD-KIT kit is installed.
BTU Specications
Preparation
CAUTION! Risk of Burns! The replace should be
turned o and cooled before contemporary kit is installed.
• Remove the STPR-MOD-KIT burner assembly from
the base pan assembly by removing four screws.
• Shut o gas supply and disconnect electrical power.
• Remove decorative fronts, glass assemblies, lava
rock, embers and logs, if previously installed.
Models
(U.S. or Canada)
Maximum
Input
BTU/h
Minimum
Input BTU/h
Orice
Size
(DMS)
STPR-MOD-KIT
(NG)
(0-2000 FT)
38,000 26,000 32
STPR-MOD-KIT
(PROPANE)
(0-2000 FT)
29,000 19,000 52
To Next Page
Need help?
General
