Heat & Glo VIENNA-II User Manual

1
Underwriters Laboratories Listed
Homologuée Underwriters Laboratories
Installers Guide
Guide d’installation
WARNING: If the information in these
instructions is not followed exactly, a
fire or explosion may result causing
property damage, personal injury or
death.
- Do not store or use gasoline or other
flammable vapors and liquids in the vi-
cinity of this or any other appliance.
- WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch.
• Do not use any phone in your
building.
• Immediately call your gas supplier
from a neighbor's phone. Follow the
gas supplier's instructions.
• If you cannot reach your gas sup-
plier, call the fire department.
- Installation and service must be
performed by a qualified installer,
service agency, or the gas supplier.
– Ne pas entreposer ni utiliser d’essence
ni d’autres vapeurs ou liquides
inflammables dans le voisinage de cet
appareil ou de tout autre appareil.
– QUE FAIRE SI VOUS SENTEZ UNE
ODEUR DE GAZ
• Ne tentez pas d’allumer d’appareil.
• Ne touchez à aucun interrupteur. Ne
pas vous servir des téléphones se
trouvant dans le bâtiment où vous
vous trouvez.
• Évacuez la pièce, le bâtiment ou la
zone.
• Appelez immédiatement votre
fournisseur de gaz depuis un voisin.
Suivez les instructions du fournisseur.
• Si vous ne pouvez rejoindre le
fournisseur de gaz, appelez le service
des incendies.
– L’installation et l’entretien doivent être
assurés par un installateur ou un service
d’entretien qualifié ou par le fournisseur
de gaz.
AVERTISSEMENT: Assurez-vous de
bien suivre les instructions données
dans cette notice pour réduire au mini-
mum le risque d’incendie ou d’explosion
ou pour éviter tout dommage matériel,
toute blessure ou la mort.
1. Cet appareil peut être utilisé dans un mobile
home, installé à demeure si les règlements
locaux le permettent.
2. Cet appareil ne peut être utilisé qu’avec le
type de gaz spécifié sur la plaque de
caractéristiques. Il n’est pas convertible et
ne peut pas fonctionner avec d’autres gaz
que celui indiqué, à moins qu’un ensemble
homologué ne soit utilisé.
1. This appliance may be installed in an after-
market, permanently located, manufactured
(mobile) home, where not prohibited by lo-
cal codes.
2. This appliance is only for use with the type
of gas indicated on the rating plate. This
appliance is not convertible for use with
other gases, unless a certified kit is used.
585-900EFD 10/01
Model/Modèles:
Vienna I and II

Heat & Glo VIENNA-II Specifications

General

Fuel Type	Gas
Log Set Material	Ceramic Fiber
Warranty	Limited Lifetime
Ignition Type	Electronic Ignition
Venting	Direct Vent

Summary

Safety and Warning Information

General Safety Precautions

Covers crucial warnings regarding gas leaks, electrical switches, and evacuation procedures.

Installation and Operation Safety

Details safety measures for appliance installation, clearances, and handling.

Approvals and Codes

Appliance Certification

Lists the certification standards and laboratories for the gas stove models.

Installation Codes

Outlines requirements for conforming to local and national installation codes.

High Altitude Installations

Provides guidelines for installing the unit at higher elevations, including input rating adjustments.

Getting Started

Introduction to Heat-N-Glo Stoves

Introduces direct vent gas stoves and their operating principles.

Pre-installation Preparation

Covers essential steps before installation, including checking parts and handling.

Installing the Stove

Locating the Stove

Details space and clearance requirements for positioning the stove within a room.

Installing the Vent System

Comprehensive guide to installing the direct vent system components and terminations.

Vent System Approvals

Specifies approved vent pipe components and terminations for the stove model.

Straight Vertical Vent System Installation

Instructions for installing vertical vent systems, including baffles and restrictors.

Installing Vent Components

Step-by-step process for attaching and securing vent pipe sections.

Installing Firestops

Procedures for installing firestops through combustible walls and ceilings for safety.

Vent Termination

Guidance on attaching and positioning the vent termination cap on the exterior.

Gas Control System Installation

Instructions for connecting and setting up the millivolt control valve system.

Gas Supply Line Installation

Details on installing the gas supply line, including shut-off valves and purging.

Gas Pressure Requirements

Specifies required gas pressure settings for natural gas and propane operation.

Stove Wiring

Electrical wiring instructions for the appliance and optional accessories.

Wall Switch Wiring

Instructions for installing an optional wall switch for stove operation.

Finishing the Installation

Covers final touches like combustible mantel clearances and hearth extensions.

Installing Logs and Ember Material

Guide on positioning logs and placing ember material for realistic flame appearance.

Pre-Lighting Checks

Crucial checks before lighting the stove, including gas leaks and vent obstructions.

Maintaining and Servicing Your Stove

Stove Maintenance Overview

General guidelines for routine maintenance and annual check-ups by a qualified technician.

Replacing Ember Material

Procedure for replacing old ember material with new material annually.

Cleaning Burner and Controls

Instructions for cleaning internal components like the burner and control compartment.

Checking Flame Patterns

How to visually inspect flame patterns and height for proper operation.

Checking Vent System

Regular inspection of the external vent cap and overall system function.

Cleaning Glass Door

Steps for safely cleaning the glass door, including precautions for hot surfaces.