PART
NUMBER
0
(1
22 kE2 (red-red-orange).
°
Page 8
The
steps
performed in
this
Pictorial are in
this area of the circuit board.
START
)
Six
27
k1
-
2,
1/4-watt
(red-violet-
orange) resistors.
'r
1,,1
Solder the leads to the foil and cut
off the excess lead lengths.
NOTE:
DIODES
MAY
BE
SUPPLIED
IN ANY OF THE FOLLOWING SHAPES.
ALWAYS POSITION THE BANDED END
AS SHOWN ON THE CIRCUIT BOARD.
--
"I
>
BAND OR BANDS
(`I)
Eight 1N4149 diodes (#56-56).
IV)
1
N2071 diode (#57-27) at D201.
Solder the leads to the foil and cut
_
off the excess lead lengths.
CONTINUE
.)."-) 15 kSl, 5% (brown-green-orange).
1 27
kS2
(red-violet-orange).
4M1
-
) 8200 E2, 5% (gray-red-red).
-
1=
-
)
56 kE2 (green-blue-orange).
N) 120 kE2,X, (brown-red-yellow).
't
°
1 56 kE2 (green-blue-orange).
( ) 12 k2, 5% (brown-red-orange).
) Solder the leads to the foil and ct
off the excess lead lengths.
\s) 8200 E2, 5% (gray-red-red).
1 N4002 diode (#57-65) at D203.
\(,-) 1 N4002
diode (#57-65) at D202.
1N4166A
zener diode (#56-25)
2D201.
( '") 220 ft (red-red-brown).
) Solder the leads to the
foil and
cL
off the excess lead lengths.
PICTORIAL 2-2
To Next Page
Loading...