Page 18
Ni
Green wire to lug 5 of switch E (S
-
1).
Yellow wire to lug 2 of switch D (S-1).
Orange wire to lug 2 of switch C (S-1).
‘‘
,
44 ) Connect the orange wire coming from hole AS to
5
of switch F (NS).
Connect the 1" red wire from lug 1 of switch D (S-2) \
II
)
to lug 6 of switch E (S-1).
Connect the 3" brown wire from lug 1 of switch C
(S-2) to lug 1 of switch F (S-1).
Locate the 1" wide length of fish paper. Then remove
its paper backing and apply the fish paper to the
indicated corner of the power transformer as shown in
Pictorial 4-1. See inset drawing #4.
Refer to Pictorial 5-1 for the following steps.
NOTE: In the following steps, you will connect wires
coming from the main circuit board to parts mounted on the
cabinet bottom.
Connect the free ends of the 5-wire cable as follows:
^L
i
) Blue wire to lug 2 of switch F (S-1).
Viblet wire to lug 6 of switch F (NS).
) Connect the 1" orange wire from lug 2 of switch E
(S-1) to lug 5 of switch F (S-2).
Connect the 1" violet wire from lug 1 of switch E
(S-1) to lug 6 of switch F (S-2).
Connect the violet wire coming from hole U to lug 1
of the speaker (S-1).
Connect the gray wire coming from hole A! to lug 2
of the speaker (S-1).
PICTORIAL 5-1
) Brown wire to lug 1 of switch C (NS).
From the remaining miscellaneous lengths of wire,
prepare the following wires:
1" red
3" brown
Prepare the following wires:
1" orange
1" violet
To Next Page
Loading...