Heathkit IM-4100 - Page 19

Gag HEATHKIT®
NOTE: DIODES MAY BE SUPPLIED
IN ANY OF THE FOLLOWING SHAPES. }
BAND OR BANDS
When you install diodes, always position
the banded end as shown on the circuit
board.
BANDED
END
Sta al
Install five 1N4149 (#56-56) diodes at:
Pe Aes ee a ew ee ef fo oh e
D6: 1N4653 (#56-44) zener diode. ; “=
) Install five 1N4002 (#57-65) diodes | g.
at D7 through D11. a) 4+
Za
va) Solder the leads to the foil and cut 5
off the excess lead lengths.
LL
(eA) R21: 680 Q (blue-gray-brown).
) R22: 680 Q (blue-gray-brown). |
R23: 150 Q (brown-green-brown). G
—
(~4,
R33:
270
Q
(red-violet-brown).
<__
p R27: 470 Q (yellow-violet-brown).
(J Solder the leads to the foil and cut
off the excess lead lengths.
PICTORIAL 2-2
Page 15