Service and Maintenance
6–6 Edition September 2000
ABC
Attention: Ensure not to damage the
white reflection area behind the lamps.
You may not clean it or touch it with
other objects, e.g. finger nails or rings.
6. Lift the defective fluorescent lamp out of
its mounting post.
Note: It is imperative that you only use clean
fluorescent lamps. If necessary, clean the lamp
before installation. Finger prints should likewise
be avoided as the grease can reduce the length of
operation.
7. Place the new fluorescent lamp into the mounting
post in such a way that it makes good contact.
8. Screw the reflection profile back into place and
secure it in the inner part of the lid.
9. Reconnect the device and switch it on.
1
2
To Next Page
Loading...
Need help?
General
