TURN PLUS | Automatic working plan generation (AWG) submode
7
634
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
Machining sequence Milling, finishing
Main mach.
operation
Anc. mach.
operation
Machining location
Design
Milling
Contour analysis: Determining the milling
contours
Sequence – Milling operation:
Linear and circular slots
Open contours
Closed contours (pockets), single surfaces
and centric polygons
Sequence – Location:
Front (also machines Y front)
Lateral surface (also machines Y surface)
– then the elements are machined according to
the sequence of geometrical definition
– – Finish-machine all elements at all machining
locations
–
Front
Finish-machine all elements on the front face
–
Lateral
Finish-machine all elements on the lateral
surface
Contour, Slot
milling, Pocket
(*)
– Finish selected element at all machining
locations
Contour, Slot
milling, Pocket
(*)
Front
Finish selected element on the face
Contour, Slot
milling, Pocket
(*)
Lateral
Finish selected element on the lateral surface
*: Define the milling operation
Machining sequence Cut-off
Main mach.
operation
Anc. mach.
operation
Machining location
Execution
Cut-off All
– The workpiece is cut off
Full-surface
machining
– The workpiece is cut off and rechucked
Machining sequence Rechucking
Main mach.
operation
Anc. mach.
operation
Machining location
Execution
Rechucking Full-surface
machining
– The workpiece is rechucked.
To Next Page
Loading...
