HEIDENHAIN CNC PILOT 640 - Units - Milling in C axis group

Overview of units | Units – "Milling in C axis" group
9
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
667
9.4 Units – "Milling in C axis" group
"Milling in C-axis, face" group
Unit Description Page
G791_Nut_Stirn_C G791 Linear slot
Milling a linear slot
Page 169
G791_Lin_Stirn_C G791 Linear slot pattern
Milling of linear slots in a linear pattern
Page 170
G791_Cir_Stirn_C G791 Circular slot pattern
Milling of linear slots in a circular pattern
Page 171
G797_STIRNFR_C G797 Face milling
Milling various figures as islands
Page 172
G797_ICP G797 face milling ICP
Milling closed contours as islands
Page 182
G799_GewindeFR_C G799 Thread milling
Inside thread milling in a single hole
Page 173
G840_FIG_STIRN_C G840 Contour mllg., figures
Milling figures inside, outside and on the contour
Page 174
G84X_FIG_STIRN_C G84X Pocket millg., figures
Roughing out closed figures, inside
Page 176
G801_GRA_STIRN_C G801 Engraving
Engraving characters strings on the face
Page 178
C-axis ICP face milling group
Unit Description Page
G840_Kon_C_STIRN G840 Contour milling, ICP
Machining ICP contours on the front face inside, outside and on the
contour
Page 179
G845_TAS_C_STIRN G845 Pocket milling, ICP
Inside rough-out of closed ICP contours on the front face
Page 180
G840_ENT_C_STIRN G840 Deburring
Deburring ICP contours on the front face
Page 194