HEIDENHAIN CNC PILOT 640 - Page 680

Overview of G codes | Overview of G commands in the MACHINING section
10
680
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
Cycles for turning
Simple turning cycles Page
G80 Cycle end
Page 339
G81 Simpl.longit.drill.
Page 499
G82 Simpl. face drill.
Page 500
G83 Repeat contour cycle
Page 501
G86 Simple recessing cycle
Page 501
G87 Cycle radius
Page 504
G88 Cycle chamfer
Page 504
Drilling cycles Page
G36 Thread boring
Page 312
G71 Simple drilling
Page 373
G72 Boring/cnt-sink
Page 375
G73 Tapping
Page 376
G74 Deep boring
Page 378
Undercuts Page
G25 Undercut
Page 258
G85 Cycle undercut
Page 361
G851 Undercut DIN 509 E
Page 363
G852 Undercut DIN 509 F
Page 365
G853 Undercut DIN 76
Page 367
G856 FORM U undercut
Page 369
G857 FORM H undercut
Page 370
G858 FORM K undercut cy.
Page 370
Contour-based turning cycles Page
G740 Repeat contour cycle
Page 329
G741 Repeat contour cycle
Page 329
G810 Longitud. roughing
Page 317
G820 Face roughing
Page 320
G830 Contour parallel
Page 323
G835 Contour cycle, bidirectional
Page 325
G860 Simple recessing cycle
Page 327
G869 Recessing
Page 331
G870 Recess cycle
Page 334
G890 Finish contour
Page 335